Products: Display Controllers

Q01.How should I terminate the unused input pins?

A．Terminate the pins as indicated below.
TEST[1:0]: Connect to GND
SCANEN: Connect to GND

Q02. Do you have any examples of register settings for connecting panels?

A．Yes. Please refer to the application notes here.

Q03. Can you recommend specific manufacturers or models for SDRAM?

A．Epson has no recommendation in particular . The SDRAM used on our S1D13517 evaluaion board is available from Integrated Silicon Solution, Inc. Please refer to Integrated Silicon Solution, Inc for SDRAM details.

Q04. Do you offer related software or device drivers?

A．Related software and device drivers are available at the URL below.

http://vdc.epson.com/index.php?option=com_docman&task=cat_view&gid=330&Itemid=99

Q05. Do you offer an evaluation board?

A．We provide the S1D13517 evaluation board (S5U13517P00C100).
Please contact a Seiko Epson sales representative.

Q06. Please provide a contact address in the event of cases in which the product fails to operate normally.

A．Please contact a Seiko Epson sales representative.

Q07. Please explain about auto increment condition for the parallel interface.

A．Open the "S1D13517 Display Controller Technical Manual" first. The HCS# pin signal described in Figure 11.1 to 11.4 (see page 93 to 97) stays active "low" in the automatic increment mode,- But, as long as the AC timing matches the timing described in Figure 8.6(see page 33), it can be changed to "high" every time the register address increments.
(CPU can access to the bus of other devices when HCS# is in "high".)

S1D13517 Display Controller Technical Manual
http://vdc.epson.com/index.php?option=com_docman&task=cat_view&gid=1706&Itemid=99

Q08.Do you offer an IBIS model?

A．Yes. Please refer to the attached file.

S1D13517 IBIS model